Hunter 59012 52 Windspan - Manual (Page 12)

www.HunterFan.com
1.888.830.1326
Feed the wires through the center
hole of the heat shield, then wrap the
keyhole slots around the screws and
twist counterclockwise.
Partially install two machine screws, found
in the hardware bag, halfway into the
motor housing. It does not matter which
two screw holes you choose.
Insert the third screw, found in
the hardware bag, into place and
then tighten all three screws.
Make sure the heat shield assembly is securely attached to
the housing mounting plate. Failure to properly attach and
tighten all three assembly screws could result in the heat
shield assembly and light fixture falling.
Heat Shield
Use only the light fixture supplied with this fan model.
Machine Screw
12
M3541-01 • 05/14/14 • © Hunter Fan Company