Remote control (continued) – Hunter 59033 52 Westover User Manual

Page 17

www.HunterFan.com

1.888.830.1326

CAUTION:

• Always purchase the correct size and

grade of battery most suitable for the

intended use.
• Clean the battery contacts and also those

of the device prior to battery installation.
• Ensure the batteries are installed

correctly with regard to polarity (+ and -).
• Remove batteries from equipment which is

not to be used for an extended period of time.

• Remove used batteries promptly.

Auto Resume Feature

This fan contains a receiver with an auto resume
feature. The receiver remembers the intensity of the
light, speed and direction of the fan, and whether
the heater is on or off. When power is restored to
the receiver, the fan, light, and heater will be at the
previous settings.

Fan Operation:

To start the fan, press the speed button on the remote

at the level you desire:

• 3 for high
• 2 for medium
• 1 for low

To turn off the fan, press 0.

Light Operation:

The light button is used to turn on, dim, and turn off

the light.

To Turn the light on:
• Press the light button 1 time and the light will

come on to the previously set level.
To dim the light:
• Press and hold the light button until the light has

reached the desired level. (As you hold the button,

the light level will move throughout its entire

range within 16 seconds.) Release the button at the

desired level.
To Turn the light off:
• Press the light button 1 time for gradual off and

the light will dim automatically for approximately

20 seconds until all the way off to allow for safe exit

from the room.
• Press the light button 2 times or 1 time while the

light is dimming for instant off.

Heater Operation:

The heater button is used to turn on, and off the

heater.

• Press the heater button 1 time to turn the

heater on.
• Press the heater button again to turn the

heater off.

Note: Regardless of the speed setting on the fan,

when the ceiling fan is operating and the heater

function is turned ON, the ceiling fan automatically

switches to low-speed updraft only and will not

accept any commands from the remote until the

heater is turned off.

Heater

Light

Reverse Switch

Remote Control (continued)