Remote control – Hunter 59033 52 Westover User Manual

Page 16

www.HunterFan.com

1.888.830.1326

To install the transmitter cradle, remove

the two screws holding the switch

cover plate. Do not remove the cover

plate. Orient the cradle by lining up

the two mounting holes with those on

the cover plate. Insert and tighten the

screws. Do not over tighten. Note: For
rocker-style cover plates, break off the

tabs by pushing outward.

Rocker-

Style

Plate

Switch

Cover

Plate

Removed

Tabs

Remote Control

Install one (1) 12-Volt, type 23A, MN-21

battery (included) into the transmitter.

Clean the battery contacts and also

those of the device prior to battery

installation. Ensure the battery is
installed correctly with regard to

polarity (+ and -). Please contact your

local battery recycling center for proper

battery disposal information.

Setting the DIP switches:

You will only have to change the DIP switch settings in the
remote if you are using more than one remote controlled fan
in the same area and want to control them separately. You may
want to label your remotes to ensure you do not mix them up.

1. At the circuit breaker or fuse box, turn the power off for
the fan you want to change. Do not turn the power off at the
circuit breaker for the previously installed fan, as you may
inadvertently change the DIP switch code settings for it as well.
2. Slide the cover off the back of the remote and remove the
battery. The battery must be removed when changing DIP
switch settings.
3. Change the DIP switch settings, so that they are different
from the previously installed fan.
4. Replace the battery and cover.
5. At the circuit breaker or fuse box, turn the power back on for
the fan whose settings you are changing.
6. Within 20 seconds of restoring power, push the 3 (high), 2
(medium), and 1 (low) buttons (in that order) on the remote.

Note: The receiver (built into the fan) has a memory function
that retains the last DIP switch code setting. The setting will not
change in the event of power failure or if the power to the fan is

inadvertently shut off.

–

DIP

switches