Hunter 53014 52 Palatine - Manual (Page 6)

www.HunterFan.com
1.888.830.1326
6
M0090-01 • 12/18/13 • © Hunter Fan Company
Hanging the Fan
While holding the wires out of the way, lift
the motor assembly and place the square
hanger into the opening in the ceiling
bracket. Be sure the ground wire attached
to the hanger faces out of the large
opening in the ceiling bracket.
Ground
Wire
Note: Fan style may vary.
Screw
Hole
Locking
Screw
Screw
Hole
Once the motor is in the ceiling bracket,
use the two locking screws, found in
the hardware bag, to secure the
motor to the ceiling bracket. Then
partially install two of the motor housing
screws, found in the hardware bag,
into screw holes on opposite ends
of the hanger bracket as shown.