Hunter 28793 54 Teague - Manual (Page 14)

14
42479-01 • 09/27/2011• Hunter Fan Company
7 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Uninstalling the Light Fixture
7-13. To uninstall the light fixture, first disconnect the plug connectors
between the black wire and the red wire.
7-14. Disconnect the plug connectors between the two white wires.
7-15. Remove the two screws attaching the light kit to the lower
switch housing.
7-16. Remove the light fixture from the lower switch housing, pulling
disconnected wires through the hole in the center of the lower
switch housing.
Note: When removing the wires, pull the thin plug connector
(male) through first, and then pull the other plug connector
(female) through the hole.
7-17. Install the dummy terminals (included in the sack parts) on the
two disconnected wires in the lower switch housing.
7-18. Install the switch housing cap and plug button to the lower
switch housing.
7-19. Once you have uninstalled the light fixture, continue
with step 8-1.
Male Dummy
Terminal
Female Dummy
Terminal
Step 7-18
Cap
Plug Button
Step 7-15
Lower Switch
Housing