Zero-Max Non-SAE Mount Overhung Load Adaptors - Manual

Horizontal Applications
RPM
0 500 1000 1500 2000 2500 3000 3500 4000
200 series
3800 4400
300 series
3100 3550
400 series
3800 4400
500 series
2300 3300
600 series
2300 3300
800 series
2300 3300
900 series
1900 2700
1000 series
2400 2750
1100 series
2500 3500
1250 series
1500 2300
1500 series
1500 2300
= Use grease = consult factory for lubrication requirements
* Per grease fitting (There are 2 fittings on the 1000 and 1100 series units so the total grease is 2 times the
amounts given in the above chart
Caution – exceeding the maximum grease capacity will result in overheating of the bearing and
reduced operating life
Grease type.
Indoor conditions
High Quality NLGI #1 or NLGI #2
Outdoor conditions High Quality NLGI #1 or NLGI #2 (Synthetic grease recommended)
Severe conditions consult factory
Grease capacity
Minimum Maximum Minimum Maximum
200 series .5 oz. 1.0 oz. 900 series 4.3 oz. 8.6 oz.
300 series .7 oz. 1.4 oz. 1000 series* 13.0 oz. 15.0 oz.
400 series .4 oz. 1.0 oz. 1100 series* 13.0 oz. 15.0 oz.
500 series 2.0 oz. 4.0 oz. 1250 series 11.0 oz. 22.0 oz.
600 series 2.2 oz. 4.4 oz. 1500 series 11.0 oz. 22.0 oz.
800 series 2.8 oz. 5.6 oz.
For applications where the shaft is vertical - consult
factory for special bearing and lubrication
i t
13200 Sixth Ave N., Plymouth, MN USA 1-800-533-1731 Fax 763-546-8260 www.zero-max.com
Rev 09-05