Dings Magnetic Group Self-Cleaning Permanent Overhead Magnet User Manual

Page 5

Revised May 19, 2014

Recommended Storage of Overhead Magnets

1) On a self-cleaner, remove tension from drive belts and conveyor belts.

2) The following precautionary procedures are recommended:

a) Store magnet indoors in a low humidity, even temperature environment if possible.

b) Keep water and any other form of moisture away from the magnet while in storage.

3) This is a procedure for indoor storage only. Outdoor storage is definitely not advised and

will null and void our warranty on the magnet assembly.

4) Self-Cleaning Belt:

All belting should be stored in a cool, dry room, free from sunlight, steam pipes, oil,
water, moisture, and corrosive fumes.

5) Reducers:

PERIODICALLY INSPECT STORED OR INACTIVE DRIVES AND SPRAY OR ADD
RUST INHIBITOR EVERY SIX MONTHS, OR MORE OFTEN IF NECESSARY.
INDOOR DRY STORAGE IS RECOMMENDED.

6) Motor:

(One year or less.) Units should be stored indoors, in a clean, dry location. Winding
should be protected from excessive moisture absorption.

7) Bearings:

Rotate bearings every three months.