3 inst all ation – Camco D-Power 4 User Manual
Page 12
230 V ~ 50/60 Hz 0,5 A 060 W
600 W / 2,7 Ohm
xxxxxxx
D-POWER 2
230 V ~ 50/60 Hz 9,8 A 00 W
600 W / 4 Ohm
xxxxxxx
D-POWER 3
230 V ~ 50/60 Hz ,3 A 220 W
900 W / 4 Ohm
xxxxxxx
D-POWER 4
3 INST
ALL
ATION
USER MANUAL
D - P O W E R S E R I E S
P.
D - P O W E R
S E R I E S
3. Mains Supply
When mounting or connecting the amp always disconnect it from mains.
Only connect the D-POWER amplifier to an appropriate AC circuit and
outlet, according to the requirements indicated in the second line on the
rating plate.
Exemplary rating plates for a mains supply of 230 V ~ 50/60 Hz.
Power supply data:
Voltage Mains Frequency Current
Power Consumption
D-POWER 2
20 V
50/60 Hz
2 A
060 W
D-POWER 2
220 V
60 Hz
0,5 A
060 W
D-POWER 2
230 V
50/60 Hz
0,5 A
060 W
D-POWER 3
20 V
50/60 Hz
9,6 A
00 W
D-POWER 3
220 V
60 Hz
9,8 A
00 W
D-POWER 3
230 V
50/60 Hz
9,8 A
00 W
D-POWER 4
20 V
50/60 Hz
22,6 A
220 W
D-POWER 4
220 V
60 Hz
,3 A
220W
D-POWER 4
230 V
50/60 Hz
,3 A
220 W
3.2 On/Off Switch
The On/Off Switch is a rocker-type switch. It is located on the right side of the
front panel. To turn the amplifier on, press on the upper part of the switch. Dur-
ing power up the Clip and Signal LEDs from both channels will light up in red for
a few seconds. To turn the amplifier off, press on the lower part of the switch.
Amplifier is switched on
Amplifier is switched off
NOTE: This switch does NOT disconnect the amplifier from mains.
Make sure the mains power socket or an alternative disconnect device is
nearby and easily accessible.
The switch initiates start-up by activating the inrush current limiter. As soon as
the power amplifier is connected to the mains power supply, a voltage is sup-
plied to both the line-filter and the fused input of the controllable rectifier. Dis-
connecting the amplifier from the main power supply can only be achieved by
physically separating the amplifier from the mains by pulling the mains plug.
The mains plug therefore has to be freely accessible. Disconnect the mains plug
from the mains during a lightning storm or when the amplifier remains unused
or unsupervised for a prolonged period of time. Alternatively, you can discon-
nect the amplifier via an external all-pole disconnection from the mains.
If a power cut occurs while the amplifier is switched on, it will restart automati-
cally once the power supply has been restored. All amplifier settings prior to the
loss of power will be maintained.