BatteryMINDer 12118 - Manual (Page 6)

Rev. C-011011 Page 6 P/N VDC121PlusSeriesMNL
BatteryMINDer Plus Models 12106 / 12106A8V / 12117 / 12118
INPUT 105-130 VAC • 50/60 Hz • 0.19A
OUTPUT
12106
1A @ 6VDC
(1.33A) (@ 5.5VDC)
12106A8V
1A @ 8VDC
(1.33A) (@ 7VDC)
12117
1A @ 12VDC
(1.33A) (@ 10.5VDC)
12118
1A @ 12VDC
(1.33A) (@ 10.5VDC)
FLOAT
CURRENT
5mA – 200mA
SIZE 3.75” L x 2.5” W x 2.25” H
WEIGHT 2.3 lbs.
OPERATING
TEMPERATURE
0°F - 125°F
injury to persons.
c) Check polarity of battery posts. POSITIVE (POS, P, +) battery post usually
has larger diameter than NEGATIVE (NEG, N,–) post.
d) Determine which post of battery is grounded (connected) to the chassis. If
negative post is grounded to chassis (as in most vehicles), see (e). If positive
post is grounded to the chassis, see (f).
e) For negative-grounded vehicle, connect POSITIVE ( RED ) clip from battery
charger to POSITIVE (POS, P, +) ungrounded post of battery. Connect
NEGATIVE (
) clip to vehicle chassis or engine block away from
battery. Do not connect clip to carburetor, fuel lines, or sheet-metal body
parts. Connect to a heavy gage metal part of the frame or engine block.
f) For positive-grounded vehicle, connect NEGATIVE ( ) clip from
battery charger to NEGATIVE (NEG, N, –) ungrounded post of battery.
Connect POSITIVE (
RED ) clip to vehicle chassis or engine block away from
battery. Do not connect clip to carburetor, fuel lines, or sheet-metal body
parts. Connect to a heavy gage metal part of the frame or engine block.
g) When disconnecting charger, turn switches to off, disconnect AC cord,
remove clip from vehicle chassis, and then remove clip from battery
terminal.
h) See operating instructions for length of charge information.
16. FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE VEHICLE. A
SPARK NEAR THE BATTERY MAY CAUSE BATTERY EXPLOSION.
TO REDUCE RISK OF A SPARK NEAR BATTERY:
a) Check polarity of battery posts. POSITIVE (POS, P, +) battery post usually
has a larger diameter than NEGATIVE (NEG, N, –) post.
b) Attach at least a 24-inch-long 6-gauge (AWG) insulated battery cable to
NEGATIVE (NEG, N, –) battery post.
c) Connect POSITIVE ( RED ) charger clip to POSITIVE (POS, P, +) post of
battery.
d) Position yourself and free end of cable as far away from battery as possible
– then connect NEGATIVE (
) charger clip to free end of cable.
e) Do not face battery when making final connection.
f) When disconnecting charger, always do so in reverse sequence of
connecting procedure and break first connection while as far away from
battery as practical.
g) A marine (boat) battery must be removed and charged on shore. To
charge it on board requires equipment specially designed for marine use.