Brickcom Software Users Manual For Firmware release V3.2.x.x - Manual (Page 33)

- 32 -
EasyLink TM
EasyLink
TM
is a unique Brickcom function which allows users to assign a unique EasyLink
name to their network camera’s IP address. There is no need to configure the router to open
up ports or remember hard-to-memorize IP addresses. When this function is enabled, users
can log onto [uniqueEasyLink name].mybrickcom.com to view the camera’s web GUI and live
view.
1. Check the box to enable EasyLink TM .
2. If Auto mode is selected, the following page will be displayed. NOTE - This mode
is recommended.
3. Enter a unique EasyLink name whose length must be between 5-32 characters.
Verify that the EasyLink name is available.