1 instrument hook-up, Instrument hook-up – B&K Precision 1693-1694 - Manual User Manual
Page 12

10
5.1
Instrument Hook-Up
1. Check the rating label of the power supply and make sure it complies with your
AC mains voltage. Connect the power supply to the AC mains using the provided
power cord.
CAUTION: The AC input is double pole fusing.
2. If you do not use the analog remote control feature, make sure the remote
control ON/OFF switch on the rear panel is in the OFF position. For analog
remote control procedures, please refer to Section 5.4.
3. Switch on the power supply and the power ON/OFF LED should light up in green.
Then, adjust the output voltage to the desired voltage and switch off the power
supply.
4. If you are using remote sense, connect as described in Section 5.3. Otherwise,
skip to the next step.
5. Connect the positive polarity of the device being powered to the red (+) terminal
of the power supply.
6. Connect the negative polarity of the device being powered to the black (-)
terminal of the power supply.
7. Switch on the power supply first and the LED indicator should light up in green.
8. Switch on the equipment and the LED indicator should still remain green.
9. You can now operate the equipment. When an operation is finished, switch off
the equipment first and then switch off the power supply.
10. When disconnecting the power supply from the unit, disconnect the remote
sensing wire first, and then disconnect the output cables.
Note: Steps 2 and 4 explain how to use the special features – analog remote control
and remote sense. You can use both features at the same time or separately.