Kaiser S45I84XL User Manual
Page 8
8
EN
CONNECTING TO WATER SUPPLY AND
SEWERAGE NETWORK
Connecting the Aqua-Stop inlet hose
The inlet hose equipped with Aqua-Stop System
1
is provided with double walls.
The Aqua-Stop System ensures blocking of water
supply in case the inlet hose has broken as well as
if the air gap between the hose itself and its
corrugated shell is filled with water.
Connect the appliance to the water mains with new
hose sets only. Never reuse old hose sets.
Water pressure must amount to 0.04 MPa (min.)
and 1 MPa (max.). In case the pressure is below
the minimum value, consult the Service Centre.
• Pull the inlet hose completely out from
storage compartment located at the back of
the dishwasher.
• While adjusting to the faucet, tighten the
screw
2 of the safety inlet hose (3/4-inch
thread).
• Before starting the dishwasher, turn on the
faucet against the stop.
2
1