Antex Electronics DMX-88 USB Recording Mixer - Manual (Page 2)

DMX-88 USB Mixer User Manual
2
Antex Electronics Corporation
19160 S. Van Ness Ave.
Torrance, California 90501
www.antex.com
Copyright © 2011 Antex Electronics Corporation. All Rights Reserved. No portion of this manual may be reproduced without prior
written consent from Antex Electronics. Part number for this manual is 9000-2493-7006 Rev A.
ASIO is a trademark and software of Steinberg Media Technologies GmbH.
FCC Compliance Statement for United States Users
This equipment has been tested and found to comply with the limits for a Class A device, pursuant to Part 15 of the FCC Rules. In
order to maintain compliance with FCC regulations, shielded cables must be used with this equipment. Operation with non-approved
equipment or unshielded cables is likely to result in interference to radio and TV reception. Changes or modifications made to this
equipment not expressly approved by Antex Electronics could void the user’s authority to operate the equipment.
IMPORTANT SAFETY INSTRUCTIONS
Read Instructions – Read all Safety Instructions before operating equipment.
Retain Instructions – Save these instructions for future reference.
Heed Warnings – All warnings and these instructions should be adhered to.
Follow Instructions – All operating and use instructions should be followed.
Cleaning –Do not use liquid or aerosol cleaners. Use a damp cloth for cleaning.
Attachments – Do not use attachments not recommended by the manufacturer as they may cause hazards.
Water and Moisture – Do not use this product near water – for example near a bathtub, wash bowl, kitchen sink, out in the rain or in
a room where moisture is likely to occur.
Accessories – Do not place on an unstable surface (cart table or tripod) where tipping is a possibility.
Ventilation – Install unit in well ventilated area where self generated heat may escape. Bookcases or cabinets should have proper
venting to allow heat to escape.
Power outlet – A properly grounded wall outlet must be used. Do not use a plug adapter that bypasses the three-terminal ground
plug. Unplug the unit during a lightning storm or when not being used for prolonged periods.