American Expedition Vehicles JK Hi-Lift/Pull-Pal Mount - Manual (Page 6)

5
5.
Remove cotter pin from the Hi-Lift footplate.
Remove factory Hi-Lift footplate and replace with
AEV Hi-Lift/Pull-Pal mount Hi-Lift footplate.
Replace cotter pin.
6.
Lift jack onto accessort mount inserting the
footplate’s tab into the frame’s slot.
Remove Hi-Lift locking stud knob (assembled in
step 3B), slide through hole on jack column and
tighten securely into U-nut.
Slide Pull-Pal locking J-bar through Hi-Lift/Pull-
Pal mount frame and secure with washer and nut
knob (see illustration on pg. 3).
Slide stud knob through washer and Hi-Lift bracket
arm and hand tighten into U-nut (see illustration
on pg. 3).
IMPORTANT!
For JK Wranglers 2011 and newer YOU MUST close the rear windon before shutting the
tailgate. Failure to do so will cause the Hi-Lift Jack and Pull-Pal to break the rear window.