American Expedition Vehicles JK Heat Reduction Hood - Manual (Page 4)

2
D. INSTALL HOOD
1. Replace all under hood components in their stock location (discard factory insulation). 2007—
2012 Models have only 1 windsheild washer nozzle. You will need to purchase Mopar PN:
55078127AG to convert your windsheild washers to the 2 nozzle configuration.
2. Loosely install the hex head hinge bolts at cowl and latch the hood down. Check all gaps for
uniform fit and adjust.
3. Adjust the hood to cowl curvature. The cowl can be made to match the curvature of the hood
by adjusting and tightening the two adjustment screws on either side of the vehicle. The cowl
sides can then be slid in or out to adjust fitment.
4. Replace the cowl cover. Replace all fasteners for the cowl cover. Replace the wiper arms.
5. Reattach ground strap to the hood inner panel if originally equipped.