Aeromotive 18673 - A1000 CAMARO STEALTH KIT - Manual (Page 2)

Aeromotive Related LS Components:
Fuel Filters: Check Valves:
12301 (pump/race gas) 10 micron 15106 (6AN)
12335 (race gas/E85) 40 micron 15107 (10AN)
12305 (filter bracket)
Fuel Pressure Gauge:
Fuel Pressure Regulators: 15633 (dry 0-100psi)
13101 (10AN ports)
13109 (6AN ports) Fuel Rails:
14106 (LS1/LS6)
Electrical Components: 14114 (LS2)
16301 (pump wiring kit) 14115 (LS3/L76)
16306 (pump speed controller) 14142 (LS7)
14147 (LS1, Edelbrock 29085)
14156 (Platinum LS1/LS6)
TOP PLATE LAYOUT
The following steps are typical of most installations:
1. Disconnect the negative battery cable and drain the fuel tank.
2. Raise and support the vehicle.
3. Remove the exhaust and rear wheels from vehicle.
4. Remove driveshaft heat shield, drive shaft and fuel tank heat shield.
5. Remove the emergency brake cables from the three way tee and swing them towards the rear of the vehicle.
6. Remove the lower shock bolts.
7. Disconnect rear sub frame wiring located on passenger side frame rail.
8. Disconnect all the following connections in Figure 1-1.