Aeromotive 18667 - 6G ELIMINATOR STEALTH FUEL CELL User Manual
Page 2
The following steps are typical of most installations:
1. Find a good mounting location on your vehicle for the Aeromotive Stealth Fuel Cell. Remove any
sharp edges from the area around the fuel cell prior to mounting. Mount the cell in accordance to the
requirements set forth by your racing sanctioning body. Fuel cells should always have good solid floor
support under the cell for the weight of the fuel. The top, bottom and sides of the cell must have the
proper support. To make securing the Aeromotive Stealth Cell easier strap kits are available from
most major fuel cell manufactures.
2. Connect AN-08 lines to the tank vent fittings. Tank vent lines must be ran outside the vehicle.
3. Connect the fuel pump outlet to a fuel filter (Aeromotive p/n 12301 (10 micron) or 12335 (40 micron)).
Make sure you use high pressure (150 psi minimum) fuel line for this connection!
For AN-10 Line, Aeromotive p/n 15608, (AN-10 ORB to AN-10 Flare Union)
For AN-08 Line, Aeromotive p/n 15610, (AN-10 ORB to AN-08 Flare Union)
For AN-06 Line, Aeromotive p/n 15609, (AN-10 ORB to AN-06 Flare Union)
2x AN-08 Rollover Valve / Vent
AN-08 Return Line Port
From Fuel Pressure Regulator
AN-10 Pump Outlet