Aeromotive 17125 - A1000 EFI FUEL SYSTEM - Manual

AEROMOTIVE
Part # 17125
Generic Fuel System Kit
INSTALLATION INSTRUCTIONS
CAUTION:
Installation of this product requires detailed knowledge of automotive systems and
repair procedures. We recommend that this installation be carried out by a qualified
automotive technician.
Installation of this product requires handling of gasoline. Ensure you are working in a
well ventilated area with an approved fire extinguisher nearby. Extinguish all open flames,
prohibit smoking and eliminate all sources of ignition in the area of the vehicle before
proceeding with the installation.
When installing this product, wear eye goggles and other safety apparel as needed to
protect yourself from debris and sprayed gasoline .
WARNING!
The fuel system is under pressure. Do not open the fuel system until the pressure has
been relieved. Refer to the appropriate vehicle service manual for the procedure and
precautions for relieving the fuel system pressure
.
Aeromotive system components are not legal for sale or use on emission controlled motor vehicles.
This kit contains the following parts:
1 ea fuel pump wiring kit
1 ea 3ft length of 10 ga. Black wire
1 ea 25ft length of 10 ga. Red wire
1 ea 30 amp circuit breaker
1 ea 30 amp automotive relay
2 ea blue female blade connector
2 ea yellow female blade connector
5 ea yellow #10 stud ring connector
1 ea yellow 3/8” stud ring connector
6 ea tie-wraps
4 ft AN-10 stainless steel braided line
20 ft AN-06 stainless steel braided line
30 ft AN-08 stainless steel braided line
1 ea AN-10 90-degree hose end
1 ea AN-10 straight hose end
6 ea AN-08 straight hose end
4 ea AN-08 90-degree hose end
2 ea AN-06 straight hose end
1 ea p/n 11101 Pump
1 ea p/n 12304 Filter 100 Micron SS
1 ea p/n 12301 Filter 10 Micron Paper
1 ea p/n 13101 Fuel Pressure Regulator
1 ea Y-block Assembly
2 ea p/n 15607 AN-08 cutoff union
2 ea AN-08 o-ring
1 ea p/n 15610 AN-10 cutoff to AN-08 union
1 ea AN-10 o-ring
12 ea tie-wraps
1 ea AN-06 o-ring
8 ea AN-10 o-ring
1 ea p/n 15606 AN-06 cutoff union
3 ea p/n 15608 AN-10 cutoff union
3 ea p/n 15610 AN-10 cutoff to AN-08 union
Warning – The included Aeromotive fuel pump is not compatible with alcohol based fuels or
fuel additives!
This kit assumes you have a sumped fuel tank or fuel cell with accommodations for an AN-10
Supply line and an AN-06 return line. Fuel tank pickups will not work properly with
Aeromotive fuel systems and will be detrimental to your fuel systems life. If your fuel tank is
not sumped, we recommend having your fuel tank sumped by a qualified professional.
No fuel rails are provided with this kit, your fuel rails must have accommodations to accept
AN-08 hose ends in order to install this kit properly.