Aeromotive 17122 - SS FUEL PUMP KIT - Manual (Page 3)

1-8. Making sure to mount the pump in the upright position and using the pump mounting bracket as a template, mark and
drill two mounting holes to accept ¼” bolts (not provided). Mount the pump bracket using two ¼” bolts, nuts and lock
washers (Not provided). Slide the pump into the bracket and tighten the clamping bolt. Do not over-tighten the
clamping bolt. Doing so can permanently damage the pump motor!
Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain components, and any exhaust
components! Protect fuel lines from abrasion and road obstructions or debris.
1-9. Using one of the supplied 90-degree AN-08 hose ends and one of the supplied straight AN-08 hose ends as a guide,
measure the length of AN-08 steel braided line needed to connect the fuel tank or fuel cell outlet to the fuel pump /
filter assembly inlet. This section of fuel line should be as short as possible to reduce the tendencies for vapor lock,
cavitation, and premature wear of your Aeromotive fuel pump.
1-10. Cut and assemble the steel braided hose and hose ends as shown in Section 2.
1-11. Using the above steel braided hose assembly, connect the 90-degree end to the outlet of the fuel tank / fuel cell
and the straight end to the fuel pump / filter assembly inlet and tighten. See figure 1-4
Figure 1-4
1-12. In the vehicles engine compartment determine where your fuel pressure regulator (Not supplied) is or will be
mounted. We recommend Aeromotive p/n 13201 for 2-port applications and Aeromotive p/n 13203 for 4-port
applications.
1-13. Using one of the supplied 90-degree AN-08 hose ends and one of the supplied straight AN-08 hose ends as a
guide, measure the length of AN-08 steel braided line needed to connect the fuel pump / filter assembly outlet to the
fuel pressure regulator (Not Supplied).
1-14. Cut and assemble the steel braided hose and hose ends as shown in Section 2.
1-15. Using the above steel braided hose assembly, connect the straight end to the outlet of the fuel pump / filter
assembly outlet and the 90-degree end to your fuel pressure regulator. See Figure 1-5
Figure 1-5