Aeromotive 14102 - 86-95 5.0L GT & COBRA FUEL RAIL SYSTEM - Manual (Page 3)

21. Carefully place the fuel injectors in the fuel rails. Position the electrical connector on each fuel injector
to the opposite side of the fuel rail as the mounting bracket.
22. Install the fuel rail that has an AN-08 port plug in one end on the driver side, with the port plug facing
the front of the vehicle. This kit comes with 2 aluminum spacers which get installed between the lower
intake manifold and the fuel rail brackets. In some instances it will be required to install additional flat
washers to space the rail out further from the distributor. After insuring that the injectors are properly
seated in the intake manifold injector bores, install the driver side fuel rail mounting bolts, insuring
that the fuel rail spacers are captured between the fuel rail bracket and the lower intake manifold.
23. Install the passenger side fuel rail, being careful not to cut any of the o-rings during installation (This
fuel rail does not require any spacers between the fuel rail bracket and the lower intake).
24. Find suitable place in the vehicle’s engine compartment to mount the Aeromotive regulator, typically
on the passenger side inner fender or shock tower. Using the supplied mounting bracket as a
template, mark the bracket mounting holes and drill to accept a #10 screw.
25. With the bracket attached to the regulator, mount the bracket and regulator to the vehicle using two
#10 screws, nuts and lock washers.
26. Install one AN-06 o-ring on each of the three AN-06 union fittings.
27. Thread the side of the AN-06 union with the o-ring into each of the three AN-06 ports on the
regulator.
28. Install one AN-08 o-ring on each of the two AN-08 union fittings
29. Install on AN-08 o-ring on the AN-08 cutoff side of each of the two AN-08/AN-6 reducer unions.
30. Thread the o-ring side of each two AN-08 unions in the back of each fuel rail.