Aeromotive 14119 - 98 1_2-04 4.6L SOHC GT FUEL RAIL SYSTEM - Manual (Page 4)

23. Connect one AN-08 90-degree hose end to each of the two ports on the front end of the fuel rail.
Connect one AN-08 45-degree hose end to the passenger side of the fuel pressure sensor adapter.
Connect one AN-08 straight hose end to the driver side of the fuel pressure sensor adapter. Plan a
route for each of the two lines between the fuel pressure sensor adapter and the fuel rails, measure
the two lengths of fuel line needed. See section titled Hose and Fitting Assembly for fuel line
assembly instructions. Once the hoses are assembled, ensure there is no debris in the hose and
install them.
24. Inspect the OEM fuel supply line o-rings and replace if necessary. Place a light coat of oil on the fuel
supply line o-rings and the supply line adapter fitting to ease installation. Connect the AN-08 tee
adapter fitting to the OEM fuel supply line.
25. Using the remaining AN-08 hose end fittings as a guide, measure the required fuel line lengths
needed and make up the last two required AN-08 fuel supply lines (See section titled Hose and
Fitting Assembly). A typical configuration is pictured below.