Aeromotive 14125 - 96-98 4.6L 1_2 SOHC GT FUEL RAIL SYSTEM - Manual (Page 3)

19. With the bracket attached to the regulator, mount the bracket and regulator to the vehicle using two
#10 screws, nuts and lock washers.
20. Install one AN-10 o-ring on each of the two AN-10/AN-8 cutoff tapered flare fittings and one o-ring on
the AN-06 union fitting.Thread the side of the AN-10/AN-8 cutoff tapered fitting with the o-ring into
each of the two AN-10 ports on the regulator. Also thread the AN-6 cutoff tapered flare into the
bottom of the regulator.
21. Install one AN-08 o-ring on each of the four AN-8 cutoff tapered flare fittings.
22. Thread the o-ring side of each of the four AN-08 cutoff tapered flare fittings into the fuel rail.