AEG SKS68840F0 - Manual (Page 36)

Problem Possible cause Solution
Water flows on the
ground.
The melting water outlet does
not flow in the evaporative tray
above the compressor.
Attach the melting water outlet
to the evaporative tray.
The temperature in the
appliance is too low.
The temperature regulator is not
set correctly.
Set a higher temperature.
The temperature in the
appliance is too high.
The temperature regulator is not
set correctly.
Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high.
Let the product temperature de-
crease to room temperature be-
fore storage.
Many products are stored at the
same time.
Store less products at the same
time.
The temperature in the re-
frigerator is too high.
There is no cold air circulation in
the appliance.
Make sure that there is cold air
circulation in the appliance.
The temperature in the
freezer is too high.
Products are too near to each
other.
Store products so that there is
cold air circulation.
There is too much frost. Food is not wrapped correctly. Wrap the food correctly.
The door is not closed correctly. Refer to "Closing the door".
The temperature regulator is not
set correctly.
Set a higher temperature.
DEMO appears on the dis-
play
The appliance is in demonstra-
tion mode. (dEMo)
Keep the OK button pressed for
approximately 10 second until a
long sound of buzzer is heard and
the display shuts off for a short
time; the appliance starts working
regularly
Warning signal
The warning signals of the control and signalling system of the appliance are displayed on
the Visual Display.
The system will give out a signal if:
• An error has occurred in the operation of
the appliance. In case the electronic system
of the appliance cannot identify the real
temperature a sign will appear on the tem-
perature display.
• Until the staff of the customer service arrive
at the spot and solve the problem, the appli-
ance will continue operating with the help
of a spare program.
36 What to do if…