AAEON PFM-C20N - Manual (Page 32)

C AN B u s M o d u l e P F M - C 2 0 N
Chapter 3 Driver Installation 3 - 7
Step 5: Setup the “Monitor Port”: Please select “Port 0” or “Port 1”
as the Monitor Port. After setting, the pop out will ask you if the
setting is correct or not. Select “OK” to start monitoring CANBUS.
If you want to stop monitoring just click on “Stop” button.
Step 6: Setup the “Transmit Port.”:When you setup the “Transmit
Port,” please select the different port from the “Monitor Port.” If the
“Monitor Port” is “Port 0,” and the “Transmit Port” should be “Port 1.”
Otherwise, it will cause error messages.
Step 7: Data translation: Please fill out the boxes of ID, RTR and
Data in order. All the setting numbers are hexadecimal.
The ID of Standard frame (the box of Extended frame not be