GEARENCH SCT2036 PETOL SURGRIP Casing Tong - Manual (Page 12)

10
With heavy duty belts (0.250 inch thick, 31 cords wide)
Diameter
Belt
Part
Number
Torque
Arm
Length
(inches)
Maximum
Torque
(foot-pounds)
Maximum
Line Pull
(pounds)
18 SCTB2036-18H 45.65 105,400 27,700
18 3/8 SCTB2036-1838H 45.83 106,600 27,900
18 5/8 SCTB2036-1858H 45.95 107,600 28,100
20 SCTB2036-20H 46.62 111,900 28,800
22 SCTB2036-22H 47.60 118,200 29,800
24 SCTB2036-24H 48.56 123,800 30,600
26 SCTB2036-26H 49.54 129,600 31,400
28 SCTB2036-28H 50.51 135,100 32,100
30 SCTB2036-30H 51.48 140,300 32,700
32 SCTB2036-32H 52.46 145,600 33,300
32 1/4 SCTB2036-3214H 52.58 145,900 33,300
32 1/2 SCTB2036-3212H 52.70 146,700 33,400
36 SCTB2036-36H 54.40 155,000 34,200
38 SCTB2036-38H 55.38 159,700 34,600
WARNING: Under no circumstances should the maximum working load be
exceeded. Always use a load cell or other calibrated indicating device to monitor
the line pull on the tong to avoid an overload.
Use on couplings
The yoke plates attached to the handle have three holes. One hole is used to fix the belt to the
yoke plates. One hole is marked “PIPE”, when this hole is fixed to the handle, the tong will
latch on the pipe for the appropriate belt. The third hole is marked “COUPLING”, this hole
will allow the tong to be latched onto a coupling with a diameter of one inch over the pipe
diameter.