GEARENCH LA116 PETOL Bull Tong - Manual (Page 8)

6
Responsibility of Distributors
IT IS THE RESPONSIBILITY OF THE PURCHASERS OF GEARENCH PRODUCTS TO
CONVEY THE INFORMATION IN THIS PUBLICATION AND ANY OTHER
INFORMATION RELATING TO THE INDIVIDUAL PRODUCT, THROUGH THE
CHANNELS OF DISTRIBUTION, DOWN TO AND INCLUDING THE INDIVIDUAL
USING THE PRODUCT
NOTE:
In view of the fact that the actual use determines whether safety requirements have
been met, the ultimate responsibility to comply rests with the end user.
The service life of leaf chains can be altered by a variety of adverse operating conditions.
The following information discusses the most important of these conditions for consideration
when operating or scheduling replacement of leaf chain systems.
Overloading / Shock Loads / Side Loading
Attempting to “inch loads which are beyond the rated capacity of the tool.
Striking the tool with a hammer or other object while force is being exerted in an attempt to
loosen a “frozen” joint.
Side pull can be caused by pulling or pushing on the tong in a direction that is not along a
perpendicular plane, unleveled mounting of the tong or vise, inadequate support of the part
being broken out, and improper seating of the part being broken out in the tong or vise.
Improper seating will occur when the diameter of the part is not consistent within the width
of the tong or vise jaw.