Elmo Rietschle G-BH9 - Manual (Page 11)

Technical Data
© Gardner Denver Deutschland GmbH 11 / 32 610.44434.40.000
3.2 Electrical data
See rating plate.
3.3 Operating
conditions
Temperatures
max. permissible temperature:
+40°C [+104°F]
Nominal value:
+15°C [+59°F]
Temperature of
pumped gases:
Pump-motor units for higher fluid
temperatures on request.
max. permissible temperature:
+40°C [+104°F]
min. permissible temperature:
-15°C [+5°F]
Nominal value:
+25°C [+77°F]
Ambient
temperature:
Ambient temperatures between
25°C [+77°F] and 40°C [+104°F]
affect the permissible total
pressure difference.
At higher temperatures the winding
may be damaged and the grease
change interval may be shortened.
Pressures
Min. suction pressure: See rating plate
Max. discharge pressure
in compressor mode: See rating plate
* The total pressure difference, shown on the
rating plate, applies only for the following
conditions:
 Ambient temperature: 25°C
 Pressure for vacuum operation:
1013 mbar at pressure connection;
 Pressure for compressor operation:
1013 mbar at suction connection;
 Intake temperature (temperature of conveyed
gases at suction connection): 15°C
For ambient temperatures between 25°C and
40°C, the total pressure difference specified
on the rating plate must be reduced (at 40°C
by 10%).
Consultation with the manufacturer is essential
for such operational conditions.
Installation altitude
Max. of 1,000 m [3,280 ft] above sea level.
When installing the pump-motor unit at an altitude of
more than 1,000 m [3,280 ft] above sea level, first
inquire with the Service department.