AEG S73100KDX0 - Manual (Page 32)

Problem Possible cause Solution
Water flows on the
ground. The melting water outlet
does not flow in the evap-
orative tray above the
compressor. Attach the melting water
outlet to the evaporative
tray.
The temperature in
the appliance is too
cold. The Temperature regula-
tor may be set incorrectly. Set a warmer temperature.
The temperature in
the appliance is too
warm. The Temperature regula-
tor may be set incorrectly. Set a lower temperature.
The door is not closed
correctly. Refer to "Closing the
door".
The food temperature is
too high. Let the food temperature
decrease to room temper-
ature before storage.
The temperature in
the refrigerator is
too warm. There is no cold air circu-
lation in the appliance. Make sure that there is
cold air circulation in the
appliance.
Large quantities of food
to be cooled were put in
at the same time. Insert smaller quantities of
food to be cooled at the
same time.
The appliance does
not operate. The appliance is switched
off. Switch on the appliance.
The mains plug is not
connected to the mains
socket correctly. Connect the mains plug to
the mains socket correctly.
The appliance has no
power. There is no volt-
age in the mains socket. Connect a another electri-
cal appliance to the mains
socket. Check fuse. Con-
tact a qualified electrician.
The lamp does not
work. The lamp is defective. Refer to "Replacing the
lamp".
The door has been open
to long. Close the door.
Door interferes with
ventilation grill. The appliance is not lev-
elled. Refer to "Levelling".
Misaligned door. The appliance is not lev-
elled. Refer to "Levelling".
As much as the advice does not lead to result, call the nearest brand-mark service.
6.1 Replacing the lamp
The appliance is equipped with a long-
life LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service
Center .
6.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
32 www.aeg.com