Liberty Pumps ALM-2R - Manual (Page 4)

7000 Apple Tree Avenue
 Bergen, New York 14416 USA 
Phone: 1-800-543-2550
www.libertypumps.com
Figure E - Line-Of-Sight Illustration
acceptable line of sight
unacceptable line of sight
acceptable lines of sight
FCC ID #: SCP TAABW01
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
 This device may not cause harmful interference.
 This device must accept any interference received, including interference that may cause undesired operation.
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
 Reorient or relocate receiving antenna.
 Increase separation between equipment and receiver.
 Connect equipment into an outlet on a circuit different from that to which the receiver is connected.
 Consult dealer or an experienced radio/TV technician for help.
This equipment has been certifi ed to comply with the limits for a class B computing device, pursuant to FCC Rules. In order to
maintain compliance with FCC regulations, shielded cables must be used with this equipment. Operation with non-approved
equipment or unshielded cables is likely to result in interference to radio and TV reception. The user is cautioned that changes and
modifi cations made to the equipment without the approval of manufacturer could void the user's authority to operate this equipment.