Gorman-Rupp Pumps SE2D3A 115V 1P 1483930 and up - Manual (Page 6)

SE SERIES OM-06495
SAFETY PAGE A - 1
SAFETY - SECTION A
This information applies to SE Series
submersible motor driven pumps.
Because pump installations are seldom
identical, this manual cannot possibly
provide detailed instructions and pre­
cautions for each specific application.
Therefore, it is the owner/installer's re­
sponsibility to ensure that applications
not addressed in this manual are per­
formed only after establishing that nei­
ther operator safety nor pump integrity
are compromised by the installation.
Before attempting to open or service the
pump:
1. Familiarize yourself with this man­
ual.
2. Unplug the power cable from its re­
ceptacle to ensure that the pump
will remain inoperative.
3. Allow the pump to completely cool
if overheated.
5. Close the discharge valve (if
used).
This pump is not designed to pump vol­
atile, explosive, or flammable materials.
Do not attempt to pump any liquids for
which you pump is not approved, or
which may damage the pump or endan­
ger personnel as a result of pump fail­
ure. Consult the factory for specific ap­
plication data.
The electrical power used to operate
this pump is high enough to cause inju­
ry or death. Make certain that the power
cable receptacle is properly grounded
before installation.
The electrical power used to operate
this pump is high enough to cause inju­
ry or death. Make certain that the plug
on the pump power cable is discon­
nected from its receptacle before ser­
vicing.
The electrical power used to operate
this pump is high enough to cause inju­
ry or death. Obtain the services of a
qualified electrician to make all electri­
cal connections.
Never attempt to alter the length or re­
pair any power cable with a splice. The
pump motor and cable must be com­
pletely waterproof. Injury or death may
result from alterations.
All electrical connections must be in ac­
cordance with The National Electric
Code and all local codes. If there is a
conflict between the instructions pro­
vided and N.E.C. Specifications, N.E.C.
Specifications shall take precedence.
All electrical equipment supplied with
this pump was in conformance with
N.E.C. requirements in effect on the