beautypg.com

Gorman-Rupp Pumps PA4A60-4024T 1476457 and up User Manual

Page 18

background image

OM−06415

PA SERIES

OPERATION

PAGE C − 5

conditions, change the filter more frequently. Irreg-
ular performance and loss of power usually indi-
cate a dirty fuel filter.

Engine Oil

The engine was lubricated for test at the factory.
However, always check the lubrication level before
startup.

Consult the manual accompanying the engine,
and change the oil filter periodically as indicated. If
operated under extremely dusty conditions,
change the filter more frequently.

Air Compressor

The air compressor was lubricated for test at the
factory. However, always check the lubrication lev-
el before startup.

Consult the manual accompanying the air com-
pressor and preform all duties and checks as indi-
cated.

COLD WEATHER PRESERVATION

In below freezing conditions, drain the pump to
prevent damage from freezing. Also, clean out any
solids by flushing with a hose. Operate the pump
for approximately one minute; this will remove any
remaining liquid that could freeze the pump rotat-
ing parts. If the pump will be idle for more than a
few hours, or if it has been pumping liquids con-
taining a large amount of solids, drain the pump,
and flush it thoroughly with clean water. To prevent
large solids from clogging the drain port and pre-
venting the pump from completely draining, insert
a rod or stiff wire in the drain port, and agitate the
liquid during the draining process. Clean out any
remaining solids by flushing with a hose.