beautypg.com

Pump and seal disassembly and reassembly – Gorman-Rupp Pumps PA6C60C-F5L All serial numbers User Manual

Page 38

background image

PA SERIES

OM-05770

MAINTENANCE & REPAIR

PAGE E - 16

PUMP AND SEAL DISASSEMBLY
AND REASSEMBLY

Review all SAFETY information in Section A.

Follow the instructions on all tags, label and de­
cals attached to the pump.

This pump requires little service due to its rugged,
minimum‐maintenance design. However, if it be­
comes necessary to inspect or replace the wearing
parts, follow these instructions which are keyed to
the illustrations (see Figures 1 through 9) and the
corresponding parts lists. Maintenance and repair
instructions for the air compressor are covered
separately in the specific literature supplied by the
manufacturer.

Some pump service functions may be performed
without separating the pump end assembly from
the engine. However, the priming chamber (2, Fig­
ure 3) and discharge check valve assembly (26,
Figure 3) must be removed to service most pump
components. The following instructions assume
complete disassembly of the pump is required.

Before attempting to service the pump, shut down
the engine and take precautions to ensure that it
will remain inoperative. Close all valves in the suc­
tion and discharge lines and drain the pump cas­
ing by removing the casing drain plug (7C, Figure
4). Clean and reinstall the drain plug.

This manual will alert personnel to
known procedures which require spe­
cial attention, to those which could
damage equipment, and to those which
could be dangerous to personnel.

How­

ever, this manual cannot possibly antici­
pate and provide detailed instructions
and precautions for every situation that
might occur during maintenance of the
unit. Therefore, it is the responsibility of
the owner/maintenance personnel to
ensure that only safe, established main­
tenance procedures are used, and that
any procedures not addressed in this

manual are performed only after estab­
lishing that neither personal safety nor
pump integrity are compromised by
such practices.

Before attempting to open or service the
pump:

1. Familiarize yourself with this man­

ual.

2. Shut down the engine and discon­

nect the positive battery cable to
ensure that the pump will remain
inoperative.

3. Allow the pump to completely cool

if overheated.

4. Check the temperature and make

sure it is cool before opening any
covers, plates, gauges, or plugs.

5. Close the suction and discharge

valves.

6. Vent the pump slowly and cau­

tiously.

7. Drain the pump.

The pump may be equipped with an au­
tomatic starting system, and therefore
subject to automatic restart. Keep
hands and clothing away from the unit to
prevent injury during automatic opera­
tion. Disconnect the positive battery
cable before performing any mainte­
nance. Failure to do so may result in se­
rious personal injury.

Use only replacement parts provided or
approved by Gorman‐Rupp. Use of non‐
authorized parts may result in damage to
the equipment and/or injury to personnel
and will invalidate the warranty.