Gorman-Rupp Pumps PAH6B60-6068H IT4 1529202 and up - Manual (Page 44)

OM-06602 PAH SERIES
MAINTENANCE & REPAIR PAGE E - 21
the shaft, it is recommended that bearings
be cleaned and inspected in place. It is
strongly recommended that the bearings
be replaced any time the shaft and bear­
ings are removed.
Clean the bearing housing, shaft and all compo­
nent parts (except the bearings) with a soft cloth
soaked in cleaning solvent. Inspect the parts for
wear or damage and replace as necessary.
Most cleaning solvents are toxic and
flammable. Use them only in a well ven­
tilated area free from excessive heat,
sparks, and flame. Read and follow all
precautions printed on solvent contain­
ers.
Clean the bearings thoroughly in fresh cleaning
solvent. Dry the bearings with filtered compressed
air and coat with light oil.
Bearings must be kept free of all dirt and
foreign material. Failure to do so will great­
ly shorten bearing life. Do not spin dry
bearings. This may scratch the balls or
races and cause premature bearing fail­
ure.
Rotate the bearings by hand to check for rough­
ness or binding and inspect the bearing rollers and
balls. If rotation is rough or the rollers or bearing
balls are discolored, replace the bearings.
The bearing tolerances provide a tight press fit
onto the shaft and a snug slip fit into the bearing
housing. Replace the bearings, shaft, or bearing
housing if the proper bearing fit is not achieved.
If bearing replacement is required, straighten the
tab on the bearing lock washer (23). Use a spanner
wrench to remove the bearing lock nut (22). Re­
move the bearing lock washer.
Use a bearing puller to remove the inboard and
outboard bearings from the shaft.
Shaft and Bearing Reassembly and Installation
(Figure 6)
Inspect the shaft (25) for distortion, nicks or
scratches, or for thread damage on the impeller
end. Dress small nicks and burrs with a fine file or
emery cloth. Replace the shaft if defective.
Clean and inspect the bearings as indicated in
Shaft And Bearing Removal And Disassembly.
To prevent damage during removal from
the shaft, it is recommended that bearings
be cleaned and inspected in place. It is
strongly recommended that the bearings
be replaced any time the shaft and bear­
ings are removed.
The bearings may be heated to ease installation.
An induction heater, hot oil bath, electric oven, or
hot plate may be used to heat the bearings. Bear­
ings should never be heated with a direct flame or
directly on a hot plate.
NOTE
If a hot oil bath is used to heat the bearings, both the
oil and the container must be absolutely clean. If
the oil has been previously used, it must be thor­
oughly filtered.
NOTE
Position the outboard bearing (24) on the shaft with
the retaining ring on the bearing O.D. toward the
drive end of the shaft. The inboard bearing (27) is
equipped with a flange ring that is shipped loose
with the bearing. Install the flange ring on the shaft
prior to heating and installing the bearings.
Heat the bearings to a uniform temperature no
higher than 250
_
F (120
_
C) and slide the bearings
onto the shaft, one at a time, until they are fully
seated against the shaft shoulders. This should be
done quickly, in one continuous motion, to prevent
the bearings from cooling and sticking on the shaft.
After the bearings have been installed and allowed
to cool, check to ensure that they have not moved
during cooling. If movement has occurred, use a