beautypg.com

Gorman-Rupp Pumps VGH2 1/2B31-B 1379872 thru 1210171 User Manual

Page 12

background image

VGH SERIES

OM−06120

PAGE B − 5

INSTALLATION

When checking alignment, disconnect
the power source to ensure that the
pump will remain inoperative.

Adjusting the alignment in one direction
may alter the alignment in another direc-
tion. check each procedure after altering
alignment.

Coupled Drives

When using couplings, the axis of the power
source must be aligned to the axis of the pump
shaft in both the horizontal and vertical planes.
Most couplings require a specific gap or clearance
between the driving and the driven shafts. Refer to
the coupling manufacturer’s service literature.

Align spider insert type couplings by using calipers
to measure the dimensions on the circumference
of the outer ends of the coupling hub every 90

_

.

The coupling is in alignment when the hub ends
are the same distance apart at all points (see Fig-
ure 3A).

Figure 3A. Aligning Spider-Type Couplings

Figure 3B. Aligning Non-Spider Type Couplings

Align non-spider type couplings by using a feeler
gauge or taper gauge between the coupling halves
every 90

_

. The coupling is in alignment when the

hubs are the same distance apart at all points (see
Figure 3B).

Check parallel adjustment by laying a straightedge
across both coupling rims at the top, bottom, and
side. When the straightedge rests evenly on both
halves of the coupling, the coupling is in horizontal
parallel alignment. If the coupling is misaligned,
use a feeler gauge between the coupling and the
straightedge to measure the amount of misalign-
ment.

V-Belt Drives

When using V-belt drives, the power source and
the pump must be parallel. Use a straightedge
along the sides of the pulleys to ensure that the pul-
leys are properly aligned (see Figure 3C). In drive
systems using two or more belts, make certain that
the belts are a matched set; unmatched sets will
cause accelerated belt wear.