beautypg.com

Gorman-Rupp Pumps 03E1-B 450930 and up User Manual

Page 25

background image

0 SERIES

OM-01186

MAINTENANCE & REPAIR

PAGE E - 6

Place a block of wood against the impeller end of
the shaft (17) and tap the shaft and assembled
bearings (19 and 20) from the bearing bore.

Use a screwdriver or other suitable tool to pry the
oil seal (21) out of the bearing housing.

After removing the shaft and bearings, clean and
inspect the bearings in place as follows.

To prevent damage during removal from
the shaft, it is recommended that the bear­
ings be cleaned and inspected in place. It
is strongly recommended that the bear­
ings be replaced any time the shaft and
bearings are removed.

Clean the pedestal, shaft and all component parts
(except the bearings) with a soft cloth soaked in
cleaning solvent. Inspect the parts for wear or dam­
age and replace as necessary.

Most cleaning solvents are toxic and
flammable. Use them only in a well ven­
tilated area free from excessive heat,
sparks, and flame. Read and follow all
precautions printed on solvent contain­
ers.

Clean the bearings thoroughly in fresh cleaning
solvent. Dry the bearings with filtered compressed
air and coat with light oil.

The bearings must be kept free of all dirt
and foreign material. Failure to do so will
greatly shorten bearing life. Do not spin
dry bearings. This may scratch the balls or
races and cause premature bearing fail­
ure.

Rotate the bearings by hand to check for rough­
ness or binding. If rotation is rough, replace the
bearings.

The bearing tolerances provide a tight press fit
onto the shaft and a snug slip fit into the pedestal.
Replace the bearings, shaft, or pedestal if the
proper bearing fit is not achieved.

If bearing replacement is required, use a suitable
puller or an arbor (or hydraulic) press to remove
the bearings from the impeller shaft.

Shaft and Bearing Reassembly and Installation

Clean and inspect the bearings as indicated in
Shaft and Bearing Removal and Disassembly.

To prevent damage during removal from
the shaft, it is recommended that the bear­
ings be cleaned and inspected in place. It
is strongly recommended that the bear­
ings be replaced any time the shaft and
bearings are removed.

Inspect the shaft for distortion, nicks or scratches
or damage. Dress small nicks and burrs with a fine
file or emery cloth. Replace the shaft if defective.

The bearings may be heated to ease installation.
An induction heater, hot oil bath, electric oven, or
hot plate may be used to heat the bearings. Bear­
ings should never be heated with a direct flame or
directly on a hot plate.

NOTE

If a hot oil bath is used to heat the bearings, both the
oil and the container must be absolutely clean. If
the oil has been previously used, it must be thor­
oughly
filtered.

NOTE

When installing the outboard bearing (19), position
the bearing on the shaft with the integral bearing
seal facing the drive end of the shaft.

Heat the bearings to a uniform temperature no
higher than
250

_F (120_C) and slide the bearings