beautypg.com

Gorman-Rupp Pumps 81 1/4A52-B 1287356 and up User Manual

Page 24

background image

OM−01524

80 SERIES

MAINTENANCE & REPAIR

PAGE E − 5

Impeller Removal

Immobilize the impeller by wedging a block of
wood or a brass rod between the vanes.

Install the shaft key (17). Install a lathe dog on the
drive end of the shaft (18) with the V" notch posi-
tioned over the shaft key.

With the impeller rotation still blocked, see Figure 2
and use a long piece of heavy bar stock to pry
against the arm of the lathe dog in a counterclock-
wise direction (when facing the drive end of the
shaft). Use caution not to damage the shaft or key-
way. When the impeller breaks loose, remove the
lathe dog, key and wood block. Unscrew the im-
peller in a counterclockwise direction.

Turn

Counterclockwise

Lathe Dog Arm

V" Notch

Shaft Key

Impeller

Shaft

Lathe Dog

Setscrew

Heavy

Bar Stock

Figure 2. Loosening Impeller

Inspect the impeller and replace it if cracked or
badly worn. Slide the impeller adjusting shims (29)
off the impeller shaft. Tie and tag the shims, or
measure and record their thickness for ease of
reassembly.

Seal Removal

(Figures 1 and 3)

Remove the spring centering washer (30) and seal
spring.

Apply oil to the seal area of the shaft. Remove the
hardware (19, 20 and 21) securing the intermedi-
ate to the bearing housing (12). Slide the interme-

diate and seal assembly off the shaft, using caution
not to drop the rotating portion of the seal as it sep-
arates from the shaft.

Position the intermediate on a flat surface with the
impeller side down. Use a suitably sized dowel to
press the seal stationary seat and element out of
the intermediate from the back side.

If no further disassembly is required, see Seal
Reassembly and Installation.

Shaft And Bearing Removal And Disassembly

When the pump is properly operated and main-
tained, the bearing housing should not require dis-
assembly. Disassemble the shaft and bearings
only when there is evidence of wear or damage.

Shaft and bearing disassembly in the field
is not recommended. These operations
should be performed only in a properly
equipped shop by qualified personnel.

Remove the slinger ring (13) from the shaft. Re-
move the bearing housing mounting hardware
from the base. Tie and tag any shims used under
the mounting feet for leveling.

Use snap ring pliers to remove the bearing retain-
ing ring (15) from the bearing housing bore. Re-
move the bearing shim set (16); tie and tag the
shims, or measure and record their thickness for
ease of reassembly.

Place a block of wood against the impeller end of
the shaft, and tap the shaft and assembled bear-
ings (14 and 14A) out of the bearing housing.

After removing the shaft and bearings, clean and
inspect the bearings in place as follows.

To prevent damage during removal from
the shaft, it is recommended that bearings
be cleaned and inspected in place. It is
strongly recommended that the bearings