beautypg.com

Gorman-Rupp Pumps 14A22-B 1064248 and up User Manual

Page 29

background image

10 SERIES

OM-00661

MAINTENANCE & REPAIR

PAGE E - 6

to the sleeve and work it up under the bellows.
Slide the rotating portion of the seal off the sleeve.
Use a stiff wire with a hooked end to remove the
stationary element, seat and O‐rings from the seal
plate. Slide the seal plate (42) and oil seal (37) off
the shaft.

NOTE

An alternate method of removing the seal assembly
is to slide the seal plate, shaft sleeve and seal as­
sembly off the shaft as a single unit. Place the seal
plate on a flat surface with the impeller side down.
Use a suitable sized dowel to press the seal com­
ponents from the seal plate. Press the oil seal from
the seal plate.

Inspect the seal plate and replace it if cracked or
badly worn.

If no further disassembly is required, see Seal
Reassembly and Installation
.

Shaft and Bearing Removal and Disassembly

When the pump is properly operated and main­
tained, the pedestal should not require disassem­
bly. Disassemble the shaft and bearings only
when there is evidence of wear or damage.

Shaft and bearing disassembly in the field
is not recommended. These operations
should be performed only in a properly‐
equipped shop by qualified personnel.

Remove the pedestal drain plug (31) and drain the
bearing lubricant. Clean and reinstall the drain
plug.

Remove the slinger ring (36).

Using snap ring pliers, remove the bearing retain­
ing ring (23) from the pedestal bore. Remove the
bearing shim set (21); tie and tag the shims or mea­
sure and record their thickness for ease of reas­
sembly.

Loosen the setscrews (26) in the bearing retainer
(24). Pry the bearing retainer from the pedestal

bore using two screwdrivers against the heads of
the machine screws.

Press the oil seal (28) from the bearing retainer,
and remove the bearing retainer O‐ring (22).

Remove the hardware (34 and 35) and remove the
the assembled bearing cover (15) and oil seal.
Press the oil seal (32) from the bearing cover.

Place a block of wood against the drive end of the
shaft and tap the shaft and assembled bearings
(16 and 20) from the pedestal. Be careful not to
damage the shaft.

After removing the shaft and bearings, clean and
inspect the bearings in place as follows.

To prevent damage during removal from
the shaft, it is recommended that bearings
be cleaned and inspected in place. It is
strongly recommended that the bearings
be replaced any time the shaft and bear­
ings are removed.

Clean the pedestal, shaft and all component parts
(except the bearings) with a soft cloth soaked in
cleaning solvent. Inspect the parts for wear or dam­
age and replace as necessary.

Most cleaning solvents are toxic and
flammable. Use them only in a well ven­
tilated area free from excessive heat,
sparks, and flame. Read and follow all
precautions printed on solvent contain­
ers.

Clean the bearings thoroughly in fresh cleaning
solvent. Dry the bearings with filtered compressed
air and coat with light oil.

Bearings must be kept free of all dirt and
foreign material. Failure to do so will great­
ly shorten bearing life. Do not spin dry