beautypg.com

Gorman-Rupp Pumps 13D1-L70EE 1258889 and up User Manual

Page 27

background image

10 SERIES

OM-05462

MAINTENANCE & REPAIR

PAGE E - 10

Install the suction and discharge lines and open all
valves. Make certain that all piping connections are
tight, properly supported and secure.

Be sure the engine has been properly lubricated,
see LUBRICATION.

Remove the fill plug assembly (7). Fill the pump
casing with clean liquid. Reinstall the fill plug and
tighten it.

Refer to OPERATION, Section C, before putting
the pump back into service.

LUBRICATION

Seal Assembly

(Figure 2)

The seal assembly is lubricated by the medium be­
ing pumped. No additional lubrication is required.

Engine

Consult the literature supplied with the engine, or
contact your local Honda engine representative.