beautypg.com

Figure 6. automatic lubricating grease cup – Gorman-Rupp Pumps 86A2-F4L 1322538 and up User Manual

Page 35

background image

OM-00957

80 SERIES

MAINTENANCE & REPAIR

PAGE E - 15

GREASE

FITTING

CROSS

ARM

POSITION

WHEN

EMPTY

POSITION

FOR

FILLING

POSITION

WHEN

IN USE

RELIEF

HOLE

NOTE:

When installing a new grease cup, lubricate
the cup as indicated on the installation tag
furnished with the grease cup.

Figure 6. Automatic Lubricating Grease Cup

Bearings

(Figure 2)

The intermediate was fully lubricated when
shipped from the factory. Under normal conditions,
turn the cap on the grease cup three complete
turns to add No. 0 lithium base grease to the inter­
mediate after each 250 hours of operation or once
each month, whichever comes first. Do not over‐
lubricate. Over‐lubrication can cause the bearings
to over‐heat, resulting in premature bearing failure.

If grease is forced out around the shaft as
new grease is added, the bearing cavity is
full and should be disassembled and
cleaned immediately.

There are no provisions in the bearing cavity to
drain or flush the lubricant. The pump and interme­

diate must be disassembled to completely clean
and maintain this cavity.

Under normal conditions, change the grease after
each 5000 hours of operation, or at 12 month inter­
vals, whichever comes first. Change the grease
more frequently if the pump is operated continu­
ously or installed in an environment where variable
hot and cold temperatures are common.

When lubricating a dry (overhauled) intermediate,
fill the cavity through the grease cup with approxi­
mately one‐third of a pound (151 gm) of grease
(approximately one‐third full).

For cold weather operation, consult the factory or a
lubricant supplier for the recommended grade of
lubricant.

Engine

Consult the literature supplied with the engine, or
contact your local engine representative.