Gorman-Rupp Pumps 06D17-GAR 708768 thru 1000782 User Manual
Page 26
0 SERIES
OM−01274
MAINTENANCE & REPAIR
PAGE E − 6
Remove the bearing shims (36). Tie and tag the
shims, or measure and record their thickness for
ease of reassembly.
Place the pump casing (1) on a clean surface with
the suction head opening facing up, and use a
screwdriver or other suitable tool to press the oil
seal (38) from the pump casing.
If no further disassembly is required, proceed with
PUMP AND SEAL REASSEMBLY. If the gearbox
requires disassembly, do not reassemble the
pump components at this time. Refer to GEAR-
BOX DISASSEMBLY and GEARBOX REAS-
SEMBLY, followed by PUMP AND SEAL REAS-
SEMBLY.
PUMP AND SEAL REASSEMBLY
If the gearbox requires disassembly, refer to
GEARBOX DISASSEMBLY and GEARBOX
REASSEMBLY, followed by PUMP AND SEAL
REASSEMBLY.
Pump Casing And Wear Ring Installation
If the wear ring (39) was removed for replacement,
press the replacement ring into the pump casing
(1) until it seats squarely against the shoulder bore.
The wear ring must seat squarely in the
pump casing bore or binding and/or ex-
cessive wear will result.
Position the oil seal (38) in the casing bore with the
lip positioned as shown in Figure 1. Press the oil
seal into the bore until fully seated against the bore
shoulder.
Lubricate the O-ring (37) and install it in the groove
in the intermediate (31). Install the same thickness
of bearing adjusting shims (36) as previously re-
moved.
NOTE
Shaft endplay should be between .005 and .012
inch (0,127 and 0,305 mm). Add or remove bearing
shims to achieve correct endplay.
Install the gearbox housing gasket (5) over the cas-
ing studs (32). Carefully slide the pump casing
over the shaft until fully seated against the gearbox
housing. Be careful not to damage the lip of the oil
seal on the shaft keyway. Make sure the bearing
shims remain in position in the casing bore. Secure
the casing to the intermediate and gearbox with
the nuts (33).
Seal Reassembly and Installation
(Figures 1 and 2)
Clean the seal cavity and shaft with a cloth soaked
in fresh cleaning solvent.
Most cleaning solvents are toxic and
flammable. Use them only in a well-ven-
tilated area free from excessive heat,
sparks, and flame. Read and follow all
precautions printed on solvent contain-
ers.
The seal is not normally reused because wear pat-
terns on the finished faces cannot be realigned
during reassembly. This could result in premature
failure. If necessary to reuse an old seal in an emer-
gency, carefully wash all metallic parts in fresh
cleaning solvent and allow to dry thoroughly.
Handle the seal parts with extreme care to prevent
damage. Be careful not to contaminate precision
finished faces; even fingerprints on the faces can
shorten seal life. If necessary, clean the faces with a
non-oil based solvent and a clean, lint-free tissue.
Wipe lightly in a concentric pattern to avoid
scratching the faces.
Inspect the seal components for wear, scoring,
grooves, and other damage that might cause leak-
age. Clean and polish the pinion shaft, or replace it
if there are nicks or cuts on either end (see GEAR-
BOX DISASSEMBLY). If any components are