NXG Technology NX-RF200 - Manual (Page 13)

Programming For Multiple Equipment Locations
You can operate up to 15 different equipment locations, each with an NX-
RF200 assigned a unique Receiver ID#. You program each of your remotes
to talk to the equipment locations you want by assigning each of your
devices to a receiver. First, you must add and name your receivers for the
locations they are placed in:
Step 1 - Open the RF Setup Window
The RF Setup window opens after selecting RF Control from the Program
Menu or RF Settings from the Main Menu at
www.nxgtech.com.
Step 2 - Reveal the Receiver settings
Extend the RF Setup window by clicking on the Receivers button of the RF
setup window.
Step 3 - Add, Name and Assign Receiver ID#
Using the controls at the bottom extended portion of the RF Control win-
dow, add new receivers and rename them for the equipment location.
Step 4 - Save and Download to your remote.
NX-RF200 Base Station
10
Add new receivers by clicking on
the Add button
Delete receivers by selecting them first by
clicking on their Name, then clicking the
Delete button.
You may rename the Default receiver
to something more descriptive by
clicking on the Rename button.
Assign the correct Receiver ID# for
each LOCATION by clicking on the
desired CELL and selecting the ID#
you want from the pull down list. Each
LOCATION should have a unique ID#.
It is ok to install multiple NX-RF200’s
in one location.
NX-RF200_Manual.qxd 10/27/08 12:48 PM Page 13