NXG Technology NX-RF200 - Manual (Page 10)

Controlling Four Identical Components/Zones
There are several considerations to take into account when you are
installing an NX-RF200 to control an array of identical components:
1. The RF ID# cannot be set to Code 0, the universal setting. You must
use one of the fifteen unique IR Routing addresses.
2. Each identical component must receive IR commands ONLY from a
dedicated Flasher affixed to its front panel or a rear panel direct IR
input. The SIGNAL of the remote should be set to RF ONLY for each
identical component. IR can still be utilized for other devices in your
system!
3. You must note the NUMBER of the Flasher Output you have utilized
for EACH of the identical components.
Identical Components/Zones - Step by Step via PC
Step 1 - Create and Program a Device for Each Component/Zone
Try to name each device with a descriptive title. At a minimum, label them
TV1, TV2, TV3 and so on.
Step 2 - Open the RF Setup Window
The RF Setup window opens after selecting RF Control from the Program
Menu or from the RXRF-200’s Main Menu. The RF Setup window is com-
posed of a “spread sheet” of options for EACH of your devices.
NX-RF200 Base Station
7
NX-RF200_Manual.qxd 10/27/08 12:48 PM Page 10