Kendall Howard 5000-3-40x-xx Performance 400 Series LAN Station - Manual (Page 8)

Step 7. Attach Cable Tray and Shelf Channels
Place the Cable Tray/Shelf Support in the correct position and insert (4) 2 ½” Hex
Drive Bolts. Next, turn the Channel Nut onto each of the 4 bolts just until the nut is
flush with the end of the bolt and pointing up. IMPORTANT: MAKE SURE
THAT THE GROOVES IN THE CHANNEL NUT ARE FACING THE
BENCH. There should be about 1” of space between the nut and the frame.
.
Hold the shelf channel over the (2) channel nuts while tightening the Hex Drive Bolts
with T-Handle provided. As you tighten the bolts, the channel nuts will turn and lock
into place. Make sure when completing this step that both channels are at the same
height.