Kendall Howard 5500-3-00x-xx Training Table - Manual

Assembly - Step 4:
4
DISCLAIMER: Kendall Howard LLC. endeavors to make this manual accurate and com-
plete. However, Kendall Howard LLC makes no representations or warranties of any
kind, expressed or implied, about whether the use of products contained herein would
infringe any rights or the correctness, accuracy or reliability of the information contained
herein or that said information covers all details, conditions or variations. The information
herein does not provide for every possible contingency in connection with the installation
or use of the product(s). The information contained in this document is subject to change
without notice or obligation. Kendall Howard LLC assumes no responsibility for the
accuracy, completeness or reliability of the information contained in this document. Any
reliance placed on the information is therefore strictly at your own risk.
For details about product warranty, please visit www.kendallhoward.com
a. Set the training table height on each leg assembly by un-
screwing and sliding the leg to the desired position.
b. Re-insert screws to secure
Instructions / Directions
36” Training Table
# 5500-3-00X-XX
1
I N N O V A T O R S I N P R O D U C T D E S I G N
w w w . k e n d a l l h o w a r d . c o m
A d d r e s s : 1 0 1 5 2 L i b e r t y L a n e
C h i s a g o C i t y , M i n n e s o t a , 5 5 0 1 3
U n i t e d S t a t e s o f A m e r i c a
P h o n e : 6 5 1 - 2 1 3 - 1 3 3 3
F a x : 8 0 0 - 4 1 8 - 6 8 9 7