Kendall Howard 5500-3-100-36 36 Training Table Cable Management Enclosure - Manual (Page 2)

Tools Needed:
2
Screw Driver
(1x) Left End
(9x) 1/4-20 Screw
(8x) M5x10 Screw
(1x) Right End
(2x) Male Hinge
(2x) Female Hinge
( 1x) Bottom
(1x) Door
(1x) Lock Base
Included:
Assembly - Step 1:
Secure right and left ends to the bottom of the
Cable Management Enclosure with 1/4-20” screws
Assembly - Step 3:
3
Assembly - Step 2:
a. Detach the modesty panel from the leg kit
b. Remove screws from the rear leg kit that fasten it to the table
top
c. Slide the Cable Enclosure around the modesty panel
d. Re insert screws securing the modesty panel and cable en-
closure to the leg kit.
Secure the lock base just behind the grommet opening with the
1/4”-20 screws