Andrew James AJ000268 Patio Heater - Manual (Page 8)

8
5. Fit the bottom of the table clamp to the
bottom of the middle pole underneath the
table at the height you wish the table to be
and tighten using the screw on the clamp
(you can adjust this once the appliance has
been assembled). Place the table through
the extender tube onto the middle tube so
that it rests on the bottom table clamp.
6. Screw the middle pole with the table onto
the bottom pole.
7. Feed the electrical cord through the base of
the appliance so that it runs through the
middle tube and extender tube
, leaving
adequate length to attach the head of the
appliance.
8. Lay the appliance flat and attach the
electrical cord to the head of the appliance.
Place the head of the appliance into the
extender tube and pull the cord at the base
of the appliance to create some tension in
the electrical cord. Be careful not to pull the
lead too tight as this will disconnect the
appliance.