Andrew James AJ000268 Patio Heater - Manual (Page 7)

7
Assembly of the appliance
1. Place the bottom tube on the base of the
appliance so that the holes of the tube align
with the holes on the base of the appliance.
Screw the bottom tube into the base of the
appliance using the 3 m6*10 bolts provided.
2. Fit the decorating cover over the bottom
tube of the appliance.
3. Inside the middle tube is the extender tube.
Remove this from the middle tube by
rotating it and pulling it out of the middle
tube. Raise the extender tube to the height
you wish the patio head to be at and fix the
middle tube and the extender tube using
the plastic fixation.
4. Place the top of the table clamp through
the circular hole and place it through the
middle pole.