Andrew James AJ000069 Apple Corer - Manual (Page 4)

4
Getting to know the appliance
1. Review the illustration identifying all parts of the appliance.
2. The appliance is designed for peeling, coring and slicing.
3. Caution: exposed blades are very sharp, keep your fingers away from the
blender at all times.
Peeling, Coring and Slicing
1. Take the handle (3) and push the threaded hole to the end of the shaft (2).
Hold the shaft still with one hand and turn the handle clockwise until it is
tight
2. Press the screw regulator (4) and the slide shaft back to its full capacity
3. Attach the appliance to any flat smooth surface by holding the base (5) with
one hand and pushing the clamp lever with the other hand. The appliance
should be fully attached to the surface.
4. For example push the apple, stem end first all the way onto the prongs as
illustrated in the diagram below
5. Ensure that the Peeling blade armature (6) is standing upright and the catch
is disengaged. Turn the handle until the apple is against the eye of the
coring/slicing blade (8)