beautypg.com

Filter maintenance – ProTeam GoCartVac User Manual

Page 10

background image

9

ProTeam

FILTER MAINTENANCE

1. Check the Intercept Micro Filter EACH and EVERY time

you start and finish vacuuming. A clogged and dirty

filter restricts airflow and results in reduced suction and

overheating and damage to the vacuum (Figure A).

2. While vacuuming stop periodically or as needed to shake

out the Intercept Micro Filter (Figure B). Replace with a

new filter when necessary. To install an Intercept Micro

Filter, insert filter into the inside of the Cloth Filter, then

replace the cap.

NOTE: Lift both Intercept Micro and Cloth Filters out at

the same time to avoid ripping the Micro Filter, especially

if it is full.

3. Once a month (or more often if necessary) hand or

machine wash the Cloth Filter and let it AIR DRY.

(Do not put it in the dryer.)

4. Once a week (or more often if needed) clean the dome

filter, located inside the vacuum underneath the

Intercept Micro and Cloth filters (Figure C).

a. Pull the top piece of the dome filter off and remove

the foam media (Figure D). Shake it out, rinse it,

and let it air dry thoroughly.

b. Before the next use, return the foam media to the

dome filter. Replace with new foam media if necessary.

c. Firmly snap the top piece of the dome filter into place.

NOTE: If using a high filtration disc in place of the foam

media, check it every two to three weeks. When the disc

becomes discolored, replace it with a new disc. The life of

the high filtration disc will depend greatly on the use and

care of the Intercept Micro Filter and Cloth Filter.

5. Once a month (or more often if necessary) clean the

exhaust muffler. Rinse, air dry, and return exhaust filter at

the bottom of the vacuum below the motor.

Figure B

Figure C

Figure D

Figure A

Intercept

Micro Filter

Cloth

Filter