Imetec BM2 200 User Manual

Page 6

• Close the battery compartment (7) and wait for the LCD display (1) to display the content

below.

SELECTInG THE unIT oF MEASurEMEnT
• Press the UNIT button (6) [Fig. 3] to select the unit of measurement (kg/lb and cm/ft). Each

time it is pressed, the LCD display changes the unit of measurement shown (1):

SELECTInG THE uSEr
• Press the USERS button (3) to activate the user selection mode.

• "P1" will start to flash on the LCD display (1).

• Press the USERS button (6) to switch to the next users - “P2”, “P3”, “P4”, “P5” - until your

reference number is displayed.

• The screen will display your user code for 2 seconds and then the scales is set to 0.0Kg.

• If you wish to change user, repeat the procedure as illustrated above.